In this article we will discuss how to get good sound and power from stereo of car. For enhancing the lower tones of sound and adding bass ,installation of sub woofers is the best choice. This eliminates the need for purchasing an after market stereo. Let us learn How to Install a Sub woofer in a Factory Stereo.

Before we look at the steps for doing the job we should understand why speakers would not be sufficient to power the music. It is because speakers can improve the effect of sound of having only higher tones. The intricacies of lower notes , tones and bass can be taken care only with sub woofer.

The battery of the car is disconnected till the installation is done. The negative terminal cable is removed from the terminal. A screwdriver or an appropriate wrench can be used to loosen it. A ring terminal is attached between the power cable and positive terminal of the battery. The cable for power supply is routed between the compartment where engine is kept and the vehicle’s inner cabin. There is generally an aperture for the wire but if there is no such facility a hole can be drilled and use a grommet for protection.

Before getting into the job first the amplifier kit should be run. It is made to run by connecting it to the battery’ s positive terminal. This step is done easily. They can be made to run through the carpet , by the side of seats and then to the car trunk. This is the power wire. Another wire called remote wire also should be connected to the car trunk. Run it in the same manner as the [power wire and reach the car trunk. The fuse of car lighter or even the car stereo can be used for this connection because as we turn on the car key the amplifier gets switched on.

The connector should always be in contact with the metal portion of the wire so it is sent in to make proper connections. Only the wire for insulation can be allowed to expose out.

The line out converter is successfully installed . We now need to understand what is the function of this. This LOC eliminates the need for replacement of head unit of factory as it enables the connection of RCA cables with our amplifier. For safety purposes grounding should be done. So locate a bolt made of metal. Connection is made between ground wire of the amplifier and metal bolt.

The stereo is then replaced back in the dashboard of the car. Then the battery is reconnected by placing back the negative terminal cable on the negative terminal. The clamp can be tightened with the help of a screwdriver or a wrench.

We have learnt How to Install a Sub woofer in a Factory Stereo and now its time to try installing on our own

Learn more about Auto. Stop by Author Name’s site where you can find out all about Car stereo and what it can do for you.

For information on Auto Shipping visit MetroGistics.

Other Automotive News on the Web

• I Haz Burger