In just seven steps this article will guide you on How to Install a Sub woofer in a Factory Stereo. Very often people who are passionate about adding new additional features to their car stereo like sub woofers take the help of audio professionals to do the job. But this job is not at all complicated and can be done without any experience by following simple steps. In this article we shall also discuss the importance of installation of sub woofers, tips and warning for doing this job.

Depth and powerful sound are important for good quality of music. Speakers can be installed at various places inside the car like door panels, dash and rear decks. They enhance the sound effect for higher notes. But to enjoy lower tones adding a sub woofer to a factory stereo is the best choice. Let us see how to do that now.

The first step is the disconnection of grounding cable and the battery of the vehicle. The grounding cable is connected to the vehicle’s frame through the lead that is negative. With the help of a Philips screw driver the clamps of the cables are all loosened and kept separate from the negative lead.

Second step is to find out the amplifier. If it is not an after marker amp and if it is factory installed one vehicle manual can help us locate the amplifier of the vehicle. Next step is to decide where the woofer should be placed. The choices available are car trunk or hatch back or cargo area of SUV on the rear side.

The speaker wires are routed to the place where the sub woofers are located. There are possibilities for it to be located some where away from the sub woofers, in such cases the wires can be sent through the carpets in the floor of the car. The trim panels which are present at the door openings are pried free with the help of a trim panel removal tool.

The carpets are lifted and the wires are routed through this. Hiding the wires gives a custom look and avoids clumsy look. The trim panels are replaced manually. To fit them properly, pressure must be applied uniformly through out the panel’s length.

The positive wires are then connected to the positive terminal and in the same way the negative terminals connected with the negative wires. That is in general corresponding connections between sub woofer input and the speaker wires are made. At last a re connection is established between the vehicle battery’s negative lead post and the grounding cable. Then the cable clamps are fixed in its position and re installed using a Philips screw driver.

Knowing how to install a sub woofer in a factory stereo is of great importance in maintaining a car.

Learn more about Auto. Stop by Author Name’s site where you can find out all about Car stereo and what it can do for you.

For information on Auto Shipping visit MetroGistics.